|
Taipei-Taiwan, May 5th, 2011
ETASIS ELECTRONICS™, a leading technology owner of high efficiency switching power supplies, officially unveils EFRP-PA60, the first power module with very high efficiency, highest power density, and 100% meets standard PMBus 1.2 design, which cooperates with Intel-based server as a tool of remote power management. The power module supports 1600W at 200VAC input, while 1000W at 100VAC input.
High Efficiency
EFRP-PA60 is to be 80 PLUS®-certified at platinum level. This environmental friendly unit also includes active power factor correction and soft-switching for more efficient power delivery. Swapping from an ordinary power supply to an ETASIS EFRP-PA60 supply should pay for itself in a few short months. The simple comparison is as follows:
Figure 1: Efficiency Milestone
|
|
Read more...
|
|
EFRP-S1500 EZ Swap (cold swap) advantages:
- Minimize system down time
- Lower service cost (e.g. logistic, shipping and handling, inventory and etc)
- Lower logistic burden (most customers will prefer keeping some spares on site)
- Fit 1U standard (100mm or 4”) mounting holes
- True PMBUS 1.1 interface included
- 80+ Silver High Efficiency
- Two wattages: EFRP-S1400 400W and EFRP-S1500 500W
Etasis S1500 uses 1U narrow N+1 power module (82mm wide) with optimized mounting bracket which fit nicely into standard 1U opening (100mm or 4” wide). |
|
Read more...
|
|
- High Efficiency Design with Capability of 3.3V/5V Output Current
ETASIS ELECTRONICS, Taipei, Aug. 05, 2010.
ETASIS ELECTRONICS, a leading technology owner of high efficiency switching power supplies, officially announces EPAP-S850, a power solution integrates high performance DC to DC design for standard ATX output in the general PS2 form factor. This power supply comes with fully compelling features providing extremely high +3.3V and +5V output for high performance 7U or 10U blade server.
Benefit1 - Designed for Testing More Devices
“We target the market for device testing.” said Jim Chien, CEO of ETASIS. “EPAP-S850 is the first power solution supporting 3.3V/32A and 5V/40A in PS2 form factor. The factory professionals do care about how many devices can be tested at the same time. That’s why they need an extremely large output power source for their industrial auto test equipment or device test machine. The more output power from low voltage rails, the more devices, such as memory, hard drives, PCI adapter, and video cards can be tested at the same time. The OEE (Overall Equipment Effectiveness) shall be improved by this way and saves lots of utility cost and time.
|
|
Read more...
|
News
